|
|
|
Installation Information for the Lift 'N' Go Model 210 Carrier
|
Introduction
Congratulations on your new WheelChair Carrier product purchase! The Model 210 Electric Carrier is one of the easiest ways to transport your folding wheelchair.
Both installers and operators should read all of the available manuals thoroughly before attempting any installation, operation or maintenance of the Model 210 Electric Carrier.
If you have any questions or comments concerning the installation or operation of these carriers, please contact your local dealer or WheelChair Carrier for additional technical information.
Unpacking the Carrier
Detailed below is the inventory of parts included with your carrier. If any parts are missing or if any shipping damage is noted, immediately contact your dealer or WheelChair Carrier if purchased direct. DO NOT attempt to install or use the lift with any missing or damaged parts.
The Model 210 Electric Carrier Box Contents:
1– Platform
1 – Power Post
1- Motor
1 – Pull Handle
1 – Hand Crank
1- Hinge Pin
2 - 3/16” X 1 1/4” Roll Pins
3 - Ratchet Tie Down Straps
4 - 1” Cap Plugs
4 - 1 1/4” Cap Plugs
1 - Hitch Adapter Class III
1 - Owner’s Manual
|
Important !
A minimum Class III hitch (heavy duty) and air shocks are required.
|
Mounting Instructions
1.) Attach hitch adaptor to power post, insert into 2” receiver.
2.) Mount platform to post using 1” pivot pin and 2 3/16” X 1 1/4” roll pins.
3.) Attach 12 volt wire to vehicle’s electrical system, wired directly to the battery, using a 20
amp circuit breaker. Carrier is grounded through the trailer hitch.
|
|
Important !
Refer to these drawings & instructions while mounting your carrier:
|
 Download Installation Drawings & Instructions (144 kb)
|
|
