|
|
|
Installation Information for the Tilt 'N' Tote Series Carriers
|
Introduction
Congratulations on your new WheelChair Carrier product purchase! The Tilt ‘N’ Tote series carriers are a few of the easiest ways to transport your folding wheelchair.
Both installers and operators should read all of the available manuals thoroughly before attempting any installation, operation or maintenance of the Tilt 'N' Tote series carriers.
If you have any questions or comments concerning the installation or operation of these carriers, please contact your local dealer or WheelChair Carrier for additional technical information.
|
DANGER !
Some folding wheelchairs may be unsuitable for transport on a Tilt ‘N’ Tote Series Carrier.
Please be sure that the chair meets the size constraints set for each product. Never exceed the posted weight capacity of the carrier.
|
Unpacking the Carrier
Detailed below is the inventory of parts included with your carrier. If any parts are missing or if any shipping damage is noted, immediately contact your dealer or WheelChair Carrier if purchased direct. DO NOT attempt to install or use the lift with any missing or damaged parts.
Tilt ‘N’ Tote Series Carriers Box Contents:
1- Carrier Assembly
1 -Anti-Sway Bar
1 -15” Bungee Cord
1 -3/4-10 X 3.5” Hex Head Cap Screw
1 –3/4-10 Hex Nut
1-3/4” Lock Washer
1-Extension Post
1-Lock Down Arm
2-Threaded Plastic Holders
4-Phillips Head Screws
4-Star Locking Washers
1-Owner’s Manual
Installation Instructions
These carriers require a minimum Class 1 trailer hitch with a draw bar. For proper installation, any existing tow ball must be removed from the hitch.
For the best performance, the Tilt 'N' Tote series carriers should be mounted at a height of 9-11 inches above the ground. These carriers may be mounted either above or below the draw bar to insure that the carrier is the proper height off the ground. Specialty draw bars that bring the lift closer to the ground may be purchased from a local hitch dealer.
Place the anti-sway bar above or below the draw bar, depending on the side of the hitch bar will be mounted to. Make sure that the holes on the anti-sway bar and the draw bar are aligned. The anti-sway bar must lay flat on the draw bar.
NOTE: These carriers come with a standard anti-sway bar designed to fit on a drawbar that is under 2.5” wide. Please be sure to purchase this size draw bar when purchasing a trailer hitch. Some Class 3 hitches have an extra wide drawbar that measures over 2.5” in width. If this size drawbar is encountered, please contact your local dealer or WheelChair Carrier and the proper anti-sway bar will be provided to you.
Place the carrier’s hitch body on the same side as the anti-sway bar, either above or below the drawbar.
Insert the 3/4” bolt from the bottom and tighten the bolt with the lock washer and nut provided. Make sure the bolt is secure and the carrier does not move from side to side.
Attach the extension post to the tilt arm with the four Phillips head machine screws and star washers provided.
Attach the locking arm by installing the upper and lower handles.
|
|
CAUTION ! Do Not Overtighten Plastic Handles.
|
Make sure the unit easily tilts to the ground and folds up to the bumper of the vehicle by pushing back on the tilt arm.
Make sure all of the pivot points and the latching mechanism are properly greased and move effortlessly.
|
|
