|
|
|
Operation Information for the Lift 'N' Go Model 210 Carrier
|
For the Lift 'N' Go:
1.) Use switch on motor to raise and lower platform. (Switch for carrier lights is under black cap on motor.)
2.) Secure chair to platform using the three ratchet straps provided. See tie down instructions below.
Note: Air shocks may be required...periodically check and tighten all handles, bolts, roll pins, and screws…oil all parts on a regular basis.
Securing the Chair to the Carrier
1.) To operate ratchet straps: insert loose end of strap into groove in roller part of ratchet buckle. Then ratchet it down using handle on buckle. To release ratchet strap: pull spring loaded lock in ratchet handle and open buckle until it is locked in open position. Strap will then come loose.
2.) Hook one strap into front loop on platform. Wrap strap around tiller post of the scooter (or any accessible part of the power wheelchair frame.) Then hook the other end of the strap into the same loop. Tighten down strap securely.
3.) The second strap is hooked onto the first set of side loops. Hook one end of the strap into the loop, across the floorboard of the scooter (or around the front wheel posts of a power wheelchair), and then hook the other end into the opposite loop. Tighten strap down.
4.) The third strap attaches to the second set of side loops. Hook one end of the third strap into the loop. Wrap the strap around the seat post of the scooter (or through and around the rear wheels of thepower wheelchair), and hook the other end into the opposite loop. Tighten strap down.
|
CAUTION !
Do not over-tighten straps or damage to chair could result. Do not attempt to modify your carrier in any way… this will void your warranty.
|
Storing the Carrier
When not in use, the Tilt ‘N’ Tote and Tilt ‘N’ Tote Plus can be folded up toward the bumper of the vehicle.
The carrier tilts up to the folded position by pushing back on the tilt arm the same way as the unit is tilted toward the ground for loading.
Be sure to use the tab with the yellow plastic cap as a handle to raise and lower the carrier.
Safety
|
|
CAUTION !
Do not operate this carrier without being satisfactorily instructed in the proper operation of the carrier by the dealer
or without reading the operation manual thoroughly.
|
Our wheelchair carriers have been designed and engineered for years of trouble free performance. Although with everyday use some parts may become loose or worn. Regularly inspect your carrier for any worn, loose, or damaged parts - If you find anything upon inspection, DO NOT USE THE CARRIER! Contact your local dealer or WheelChair Carrier for any repairs that need to be made. Failure to act may cause severe injury!
Our wheelchair carriers should only be used for the loading and unloading of wheelchairs for which they are designed. DO NOT add to or modify any part of the carrier system without first contacting the dealer or WheelChair Carrier. Any modifications may void the warranties as well as compromise the structural integrity of the carrier.
Always make sure the vehicle’s parking brake is firmly set before operating the carrier.
|
|
